Audison AFBMW ReAMP 3

Audison AFBMW ReAMP 3 Wiring Harness

Cable harness compatible with a 676 HiFi audio system equipped with a RAM module in conjunction with an Audison AF bit amplifier. The use of other products may require modifications and additional connections to the vehicle. The 676 HiFi system uses 2Ω woofers. Do not bridge two channels into a 2Ω load as this may trip the protection or damage the amplifier. To use the bridged channel, the user must replace the OEM 2Ω woofers with Audison APBMW S8-4.2 4Ω woofers. Please make sure to confirm correct bridge connection when assembling. Use high-level input #11 configuration (2-way front + rear + center) during the Bit Drive Wizard configuration process. This is necessary to properly route the input signal to the bit processor section. APBMW ReAMP 1, APBMW ReAMP 2 and AFBMW ReAMP 3 use identical connectors but with different pins. They are not interchangeable.

AFBMW ReAMP 3 enables:

1. Get the front and rear stereo audio signal of the OEM source.
2. Route the AF FORZA amp outputs to each of the seven OEM amp channels: (Mid-Hi FL; Mid-Hi FR; WF FL; WF FR; RL; RR; Center).
3. Plug&Play terminals allow the user to select which output of the AF FORZA amplifier connects to each of the seven channels of the OEM audio system.
4. It is also possible to bridge the outputs of the AF FORZA amplifier.
5. It leaves the OEM amp on.
6. USS1 prevents center channel speaker fault diagnosis.

Product comments

Evaluation

• Car amplifiers Cable jumpers and Plug & Play cables
• AUDISON DSP processors, amplifiers and speakers