Carbon Collective Oracle Inorganic Ceramic Coating (30 ml)
Very popular paint protection from Carbon Collective with ultra-hydrophobic properties and high gloss. In addition, it is one of the most affordable ceramic coatings on the market. Oracle can be used on various types of surfaces: on paint, on foil, on carbon, on bare metal, on aluminum and stainless steel surfaces, on plastic grids or on interior moldings. Spend more time driving and less time cleaning! Oracle creates a very durable coating on the surface, which results in considerably less maintenance (the car gets significantly less dirty).
Key Features of Carbon Collective Oracle Inorganic Ceramic Coating (30ml)
- Ultrahydrophobic.
- Hardness 3.5H.
- Durable for 2 to 3 years.
- 110° water repellency angle.
- Drainage angle up to 17°.
- High chemical resistance.
- Can be used for both gloss and matte.
- Very easy to apply, apply and wipe off.
- Innovative dropper bottle.
- In the package you will find a 30 ml glass bottle of Oracle, 2 microfiber applicators, instructions.
How to use the Carbon Collective Oracle ceramic coating
- Never work in direct sunlight.
- First, wash the car thoroughly with a good quality car shampoo.
- Always decontaminate the paint from flying rust and tar.
- If necessary, perform mechanical decontamination with Clay afterwards.
- You can read the procedure for claying in the article " waxing a car and its preparation ".
- After finishing the claying, wash the car again with shampoo, or rinse it with water and dry it thoroughly.
- Polish the paint usingDodo Juice Lime Prime , the procedure can be found again in the article on waxing. This product degreases the paint surface at the same time.
- Now the varnish is ready for the application of the ceramic coating.
- Put on protective rubber gloves before application.
- Apply the ceramic coating to the application cube to which the application cloth is attached.
- Then apply the ceramic coating to the vehicle's paint in a cross motion.
- Always apply the ceramic coating piece by piece, not the entire car. E.g. door or 1/4 hood.
- Allow to dry for 2 to 3 minutes and buff with a short-pile microfiber cloth .
- Use more cloths, we recommend using at least 4 cloths for 1 car, it is important to keep the cloth dry and clean, only then will the result be error-free.
- After 3 to 4 hours you can apply a second layer for even higher resistance.
- After application, we recommend leaving the car ideally in a warm and dry place for 24 hours so that the coating hardens.
- 2 weeks after application, we recommend not washing the car, rain does not affect the coating.
- The subsequent maintenance of the car after the application of ceramics is very simple, it is enough to wash the vehicle with a high-quality shampoo, for example Carbon Collective Lusso 2.0 .