Toyota RAV4 - new sound system with DSP processor

Toyota RAV 4 sound system including measuring the frequency response of the speakers and subsequent sound settings in the DSP processor program. We designed a completely new sound system for this car, replacing the factory system from JBL. We installed three-way speakers from the Italian ESB Audio in the front doors, which will impress you with their high-quality and genre-neutral sound for the given price, which will also support the coaxial speakers in the rear doors from the same manufacturer. An Audison subwoofer is located in the side of the luggage compartment, which supplements the newly installed sound system with the necessary dose of low frequencies. We subsequently installed 2 amplifiers from a third Italian manufacturer in the double bottom of the trunk, this time we chose Steg. Of course, part of the installation was thorough damping of the door with anti-vibration Comfortmat materials. Finally, it was time to measure and adjust the sound on the DSP processor, which is part of the 8-channel amplifier. Using a calibrated microphone, we measured all the shortcomings and obstacles of the given car and set the spatial correction of the equalizer for all speakers in the car. Subsequently, we set time corrections, bandpasses and other options that the DSP processor will allow us. The goal of this installation was to achieve high-quality, dynamic sound without distortion at higher volumes and use the potential of the speakers and adapt the sound not only to the driver's position, but also to the car in question.